Garg Casteels Pvt. Ltd.

General Design Points :

» Draft angles are not normally required.

» Try to keep casting sections to a uniform thickness.

» Avoid sharp internal corners, a small radius is preferred.

» Most hole can be cast at clearance, reaming or tapping sizes.

» Specify all numbering and lettering required and state embossed or dembossed.

» Indicate finish grinding or machining allowance if required.

» Casting feed pads are normally placed at the heaviest section, in a flat area for ease of
removal.

» A 0.010" feed witness is usually left on the casting after finishing, but can be removed flush if
required.

» When specifying casting material use one of the standards shown in this brochure if possible.

» About Investment Casting

» General Design Points

» Manufacturing Process

» Carbon Steels for General Application Low
Temperature Service

» Austenitic Steel for Corrosion - Resistant
Application

» Casting Technical

Garg Casteels Pvt. Ltd.

212 / 214, Madhav Darshan,
Waghawadi Road,
Bhavnagar -364001 (Gujarat) India.

Phone : + 91 278 - 2421596
Fax : + 91 278 - 2411481

E-mail :
gargcasteels@gmail.com
gargcasteels@yahoo.com